View previous topic :: View next topic |
Author |
Message |
Venkata Ramana Reddy Beginner
Joined: 02 Dec 2002 Posts: 70 Topics: 19 Location: California
|
Posted: Mon Dec 09, 2002 7:05 pm Post subject: Compile & Link Macros in Rexx |
|
|
In my last project,I remember very well,we used to compile & Link edit Cobol & PL/I soure programs from ISPF editor.
If would appreciate if any one can share the Rexx code for those macros.
TIA
Venkataramana |
|
Back to top |
|
|
kolusu Site Admin
Joined: 26 Nov 2002 Posts: 12370 Topics: 75 Location: San Jose
|
Posted: Mon Dec 09, 2002 7:16 pm Post subject: |
|
|
venkata Ramana Reddy,
On the ISPF primary menu you have 2 options.
- Foreground (OPTION 4)
- Batch (OPTION 5)
choose option 5
There you can choose in which language you want to compile .
It has ASSEMBLER,COBOL FORTRAN,PL/I , VPASCAL....
Choose the option based on your language and it will generate the JCL for you.
Hope this helps...
cheers
kolusu |
|
Back to top |
|
|
Venkata Ramana Reddy Beginner
Joined: 02 Dec 2002 Posts: 70 Topics: 19 Location: California
|
Posted: Mon Dec 09, 2002 7:41 pm Post subject: |
|
|
Kolusu,
Thanks.Hope I am not clear with what I want.OK this is what I am exactly looking at ....
I want to compile the source code without coming out of the source code.
I remember very well,we used to open the source code and just type CMAC(to compile) & LMAC(to link) in the command prompt and hit enter.
Hope I am clear now.... |
|
Back to top |
|
|
Premkumar Moderator
Joined: 28 Nov 2002 Posts: 77 Topics: 7 Location: Chennai, India
|
Posted: Tue Dec 10, 2002 4:06 am Post subject: |
|
|
Venkata Ramana Reddy,
Those might be edit macros developed inhouse to compile and link-edit.
I have my own edit macros that will show me the compile JCL prepared from a skeleton, for me to submit.
You may want write one. |
|
Back to top |
|
|
misi01 Advanced
Joined: 02 Dec 2002 Posts: 620 Topics: 173 Location: Stockholm, Sweden
|
Posted: Thu Dec 12, 2002 9:53 am Post subject: |
|
|
I also have developed my own execs to compile and link from within source code and/or linkage code. Not sure that they'd be any use to you since they use skeletons to build up the JCL and obviously these are customised for our installation.
I could send them to you but ONLY on the assumption that you are competent in REXX and skeletons (ie, no support from my side) |
|
Back to top |
|
|
Venkata Ramana Reddy Beginner
Joined: 02 Dec 2002 Posts: 70 Topics: 19 Location: California
|
Posted: Thu Dec 12, 2002 12:27 pm Post subject: |
|
|
Misi01,
Thank you very much for reply.Can you send the code to mail-id (ramana_pasula@yahoo.com).I will try to customize the code for our installation. _________________ Venkataramana
-- Good judgement comes from experience, and often experience comes from bad judgement. |
|
Back to top |
|
|
|
|