MVSFORUMS.com

[rajeshkoratti]

Hi,

While working in ISPF i accidently pressed the PF2 key and the screen when into 'split screen' mode. So now i can see 2 screens and toggle between them using the PF9 key. How do i come out of this 'split screen' mode other than closing all the screens?
_________________
Thanks and Regards..
Rajesh

[expat]

Without closing the unwanted screens you will remain in split screen mode.
_________________
If it's true that we are here to help others,
then what exactly are the others here for ?

[warp5]

You can place your cursor at the top of the screen and press PF2. This will make the split screen size as small as possible. There is also an option in the ISPF settings where you can always show the split line, I do not have this option set (there is no / before it). Try it out.

[Bill Dennis]

I wonder if your quesstion is this simple..if you PF3 (or =X) out of one side, you will return to a single screen.
_________________
Regards,
Bill Dennis

Disclaimer: My comments on this foorum are my own and do not represent the opinions or suggestions of any other person or business entity.

[semigeezer]

One of the 1st things I do in a new ISPF session is turn off "Always show split line" . A split always occurs where the cursor is which is why when the cursor is at the top or bottom and you press PF2 there is no split line. See also SWAP LIST command
_________________
New members are encouraged to read the How To Ask Questions The Smart Way FAQ at http://www.catb.org/~esr/faqs/smart-questions.html.

[rajeshkoratti]

May be my question and doubt was simple and stupid .. what i did was i went to the top of the screen and pressed PF2 again. and lo the screen switched back to the normal toggle mode..(without the dotted line)

Thanks for thr PF2 trick Warp and Semigeezer..
_________________
Thanks and Regards..
Rajesh