MVSFORUMS.com

kanos · Beginner Joined: 13 Dec 2004 Posts: 2 Topics: 1

I have always done this by using the open and close command.

However, I have seen someone else just typing three letters next to the output in TSO then a dialogue box appears and you can specify the DSN.

I thought it was "XCF"

Obviously its not, anyone have an idea what it actually is.

Thanks in advance.

kolusu · Posted: Mon Dec 13, 2004 6:23 am Post subject:

kanos,

The Command is XDC which displays a panel to open a data set, print after the panel is completed, then close the data set.

Hope this helps...

Cheers

Kolusu
_________________
Kolusu
www.linkedin.com/in/kolusu

kanos · Beginner Joined: 13 Dec 2004 Posts: 2 Topics: 1

kolusu · Posted: Mon Dec 13, 2004 6:37 am Post subject:

kanos,

I would really appreciate if you can stop using chat lingo on this board. Even though it appears cool, remember that you are not in a chat room , but on a professional helpboard

Thanks

Kolusu
_________________
Kolusu
www.linkedin.com/in/kolusu