MVSFORUMS.com

coolman · Last edited by coolman on Sat Feb 05, 2011 1:43 am; edited 1 time in total

I have a panel defined with 16 input lines.

ENTER YOUR TEXT : TEST_____________________________
__________________________________________________________
__________________________________________________________
__________________________________________________________
__________________________________________________________
__________________________________________________________
__________________________________________________________
__________________________________________________________
__________________________________________________________

Note that in the first line you had the word TEST and it successfully goes to subsequent panels. But, if i have the word RETURN as the first word in that first line, the application terminates abnormally. When I hit an enter, instead of giving a RC of 0, it assumes it to be 8 and ends the application. I tried saying the value of the first line, when i typed in RETURN - It doesn't even show me the value in the panel variable. I'm not facing this problem if I have RETURN as the first word in second line, keeping the first line blank.

Any suggestions.

Cheers,
Coolman
________
BMW X history

Bithead · Posted: Wed Jun 01, 2005 12:46 pm Post subject:

Try adding a command line as the first line above ENTER YOUR TEXT.

semigeezer · Posted: Wed Jun 01, 2005 1:07 pm Post subject:

or add CMD() to the )BODY statement. Adding a command line is definitely preferable.

coolman · Posted: Wed Jun 01, 2005 2:10 pm Post subject:

Thanks Bithead and Semigeezer. I went with adding CMD() to the )BODY stmt
________
vapolution vaporizer