MVSFORUMS.com

rakshith · Posted: Tue Nov 08, 2005 7:31 am Post subject: TSQ doubt

how do I look at TSQ when I am in xpeditor ?

kolusu · Posted: Tue Nov 08, 2005 7:53 am Post subject:

rakshith,

What exactly do you mean look at TSQ? You mean browse? If so why not issue a READQ TS ?

Check this link to know more about READQ TS

http://publibz.boulder.ibm.com/cgi-bin/bookmgr_OS390/BOOKS/DFHP4A04/1.148?DT=20050113150738

Hope this helps..

Cheers

Kolusu
_________________
Kolusu
www.linkedin.com/in/kolusu

rakshith · Posted: Tue Nov 08, 2005 8:06 am Post subject:

I just want to cofirm whether the TSQ is created or not when executed WRITEQ statement ? how do I do this ?
or
how do i use CEBR command when I am xpeditor ?

rakshith · Posted: Tue Nov 08, 2005 8:09 am Post subject:

I am using WRITEQ statement in my program, I am not sure it is created or not ,I just want to cofirm whether the TSQ is created or not when executed WRITEQ statement ? how do I do this ?
or
how do i use CEBR command when I am in xpeditor ?

Manas Biswal · Posted: Tue Nov 08, 2005 9:20 am Post subject:

rakshith,
You would most probably have coded HANDLE CONDITION or RESP in your program which would give you your answer of whether the WRITEQ command was successful or not. If not (though I would highly recommend either a HANDLE CONDITION or RESP clause), then you can always look at the EIB variables (EIBRCODE) to find out whether the WRITEQ command was successful or not. And of course you can use see the data in these variables while still in expeditor.

HTH...Regards,
Manas
_________________
There is no path to peace. Peace is the path.
- Mahatma Gandhi (1869-1948)