MVSFORUMS.com

arunmr4 · Beginner Joined: 19 Dec 2005 Posts: 23 Topics: 8

Hi,

A job was submitted and is now in spool. It should have been routed to SAR. Is there a way to move the job from SPOOL to SAR

Regards,
Arun

Bithead · Posted: Fri May 05, 2006 1:01 pm Post subject:

I change the output class using SDSF and make sure that it is in the output queue.

arunmr4 · Beginner Joined: 19 Dec 2005 Posts: 23 Topics: 8

Hi,
I didn't get it. Can you tell me how to do it.
Thanks

Bithead · Posted: Fri May 05, 2006 2:07 pm Post subject:

If you can get to SDSF, then look in the input (I), held (H) or output (O) queues for your job. If you can't see it, issue the command PRE *. If you still can't see it, either it is not there or you don't have access. The operators may be able to requeue it for you.

arunmr4 · Beginner Joined: 19 Dec 2005 Posts: 23 Topics: 8

Hi Bithead,
Thanks a lot for the reply. I figured out how to do it.
Arun

arunmr4 · Beginner Joined: 19 Dec 2005 Posts: 23 Topics: 8

Hi,
One more thing, what are options input (I) and held (H) for?
Arun

Bithead · Posted: Fri May 05, 2006 4:15 pm Post subject:

I - jobs awaiting execution or executing
DA - active jobs and tasks
O - awaiting output from JES (print, SAR, etc)
H - held in sppol by JES
INIT - initiators

SDSF has a lot of information in it's help panels